Vine Lace Beanie pattern

I tried to make this pattern a PDF file, but here it is in case you can't access it.

 Vine Lace Beanie

Brenda Hoffman

Gauge: About 20 sts/4 inches     Vanna’s Choice WW Yarn

Needles:  #7 & #8 16” circular needles

With a #7 needle cast on 88 sts.  Place marker to indicate beginning and work k2, p2 rib for 12 rows or 1 ½ inches.

Increase round as followed

With #8 needle, work 43, kfb, work 43, kfb  (90 sts)

Start lace pattern, starting with row 2

Lace Pattern (multiple of 9)

Row1: k                                                                                                  

Row 2: *yo, k2, skp, k2tog, k2, yo, k1 rep from * to end

Row 3: K

Row 4:*k1, yo, k2, skp, k2tog, k2, yo rep from * to end

Repeat these 4 rounds, until hat measures 6 inches

Crown

On the next round (work 43 sts, k2tog) 2 times. [88 sts]

Work one round even.

Shape crown as described below.

Round 1: *Work 6, k2tog. Repeat from * around. [77 sts remain]

Round 2 and all even rows: K

Round 3: *Work 5, k2tog. Repeat from * around. [66 sts remain]

Round 5: *Work 4, k2tog. Repeat from * around. [55 sts remain]

Round 7: *Work 3, k2tog. Repeat from * around. [44 sts remain]

Round 9: *Work 2, k2tog. Repeat from * around. [33 sts remain]

Round 11: *Work 1, k2tog. Repeat from * around. [22 sts remain]

Round 13: *K2tog. Repeat from * around. [11 sts remain]

Finishing

Cut yarn, a generous tail. Draw tail through remaining stitches on the needle. Pull gently to close hole. Weave in tail.

Weave in ends.